Our Injection Moulding
Machinery Fleet
26 horizontal machines from 50T to 450T — precision micro moulding to large format capacity, all under one roof in Johor Bahru.
One Production Floor, End to End
Our injection moulding machines run side by side with in-house finishing and packing on a single Johor Bahru site — parts move from mould to finished goods without ever leaving the site.
- 26 machines, 50T–450T
- Secondary processing on the same site
- ISO 9001 & 14001 controlled
Three Capacity Tiers
Each tier is matched to the right part size and clamping force — so your component runs on the most efficient machine for its geometry.
Small & High-Precision Components
For small, high-precision components where tight tolerances and fine detail matter most — common in consumer electronics, connectors, and miniaturised housings.
General Industrial & Consumer Parts
Our largest tonnage tier by machine count — used for general industrial and consumer product components across a wide range of part sizes. The workhorse of our production floor.
Large Structural Components
For larger structural components and parts requiring higher clamping force — covering industrial equipment housings and larger consumer product assemblies.
| Category | Tonnage Range | Units |
|---|---|---|
| Precision Micro Moulding | 50T – 100T | 5 |
| Mid-Range Industrial Components | 120T – 250T | 11 |
| Large Format Capacity | 260T – 450T | 10 |
SSM 169818-D | ISO 9001:2015 & ISO 14001:2015 Certified
Johor Bahru, Malaysia | www.industrinikkoplas.com
INJECTION MOULDING MACHINE SPECIFICATION SHEET
Full Machine Tonnage List
16 machine lines · 26 units total · 50MT – 450MT clamping force
| # | Injection Machine / Brand | Tonnage | Units |
|---|---|---|---|
| 1 | Kawaguchi KM-50B / JSW 50 EII | 50 MT | 3 |
| 2 | Lanson GT3 90 | 100 MT | 1 |
| 3 | Niigata 100A | 100 MT | 1 |
| 4 | Lanson GT3 120 | 120 MT | 1 |
| 5 | JSW 150SB II | 150 MT | 1 |
| 6 | Toshiba 170G / Kawaguchi KM180B2 | 170–180 MT | 2 |
| 7 | Lanson GT3 200S | 200 MT | 1 |
| 8 | JSW 220J-E II / Kawaguchi KM-220B2 | 220 MT | 3 |
| 9 | Toyo 220 | 220 MT | 1 |
| 10 | Toshiba 220 | 220 MT | 2 |
| 11 | Kawaguchi KM-280B2 / JSW 280EIII | 280 MT | 1 |
| 12 | Mitsubishi 290 | 290 MT | 1 |
| 13 | Lanson GT-3-LS320S | 320 MT | 1 |
| 14 | JSW J350 EIII / Toyo SI-J350 III | 350 MT | 5 |
| 15 | Lanson GT3-LS380S | 380 MT | 1 |
| 16 | JSW J450 EIII | 450 MT | 1 |
| TOTAL | 26 | ||